Pill bottle wrap label

Click any text on the label to edit it, and use the Logo button to drop in your own logo. Your edits are saved in this browser. The label is sized to wrap the bottle body once, plus a small overlap for the seam.

Your Pharmacy Name
Your Pharmacy Fidget Division, LLC
1-800-CLICK-IT
Aisle 3D, Behind the Printer • Anytown, USA • www.yourwebsite.com
Rx# CLICK-0001 [∞] Date Filled: 2026-10-10 QTY: 1 Capsule DOB: Ask Mom
YOUR NAME HERE
123 Desk Drawer • CUBICLE, IN 46000
DO Bored, Very   RPH: MS Clicksalot
Click 1 capsule by thumb as often as needed
Clickazepam (CLK) XR 1000 Clicks Capsule
NDC: 0-CLICK-CLACK | Lot: 3D-PRINTED
Unlimited refills before the heat death of the universe
Beyond Use Date: When the switch dies
Rx Only. This fidget was specially 3D printed in our pharmacy for you at the direction of your boredom. State and Federal law STRONGLY ADVISE against taking this capsule by mouth. Not a real medication. Side effects may include clicking, more clicking, and annoyed coworkers.
May cause excessive clicking
Do not swallow. It's plastic.
Keep out of reach of annoyed coworkers
No heavy machinery while fidgeting
Printing: in the print dialog, set Scale to 100% (or "Actual size"), not "Fit to page", or the label won't wrap correctly. Matte sticker paper or plain paper with clear tape both work.
Fit: defaults fit a bottle about 26.7 mm across with roughly 39 mm of straight wall below the cap. For best results, measure your printed bottle around the middle with calipers and enter that diameter. If you scale your model, scale the height by the same percentage.
Wrapping: start at the left edge on the front of the bottle. The striped strip on the right end tucks under the start.